|
RLR07C1504FS Features:
|
| The RLR07C1504FS has a 2700-Ω series base resistor for each Darlington pair for operation directly with TTL or 5-V CMOS. The RLR07C1504FS has a 10.5-kΩ series base resistor to allow its operation directly with CMOS or PMOS that use supply voltages of 6 to 15 V. The required input current is below that of the RLR07C1504FS. |
|
RLR07C1504FS (Absolute) Maximum Ratings:
|
| These devices consist of four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages. Operation from dual supplies also is possible as long as the difference between the two supplies is 2 V to 36 V, and VCC is at least 1.5 V more positive than the input common-mode voltage. Current drain is independent of the supply voltage. The outputs can be connected to other open-collector outputs to achieve wired-AND relationships. |
|
RLR07C1504FS Pinout:
|
| Notes a. Not to exceed TPULSE = 50 ns. b. Requires a 150-W resistor in GND connection. The reverse load current through the intrinsic drain-source diode has to be limited by the connected load. Pow- er dissipation is higher compared to normal operating conditions due to the voltage drop across the drain-source diode. The temperature protection is not active during reverse current operation. Input current has to be limited. (See Maximum Ratings, page 2.) http://www.campw.com/ |
| The rates of change of tempera- ture for the ramp-up and cool- down zones are chosen to be low enough to not cause deformation of the board or damage to compo- nents due to thermal shock. The maximum temperature in the reflow zone (TMAX) should not exceed 235 C. |
